Our process 

• Protect all work area's with masking and plastic
• Install plastic bearer walls isolating work area
• label all doors, drawers and hinges (doors and drawers are taken to shop)
• Wash all cabinets with a degreasing solution
• Seal all cabinets with plastic so you do not have to empty cabinets out.
• Install portable air scrubber to remove any dust or contaminants in the air that might effect the finish.
• Sand all surfaces to material TDS specifications
• Apply bonding primer (sand after)
• Apply 2 coats of top coats Note: The air scrubber is running during spraying to remove any unpleasant odors and  to remove any overspray from the air keeping your home clean . Our air scrubbers use HEPA filters to purify the air these are the same type medical laboratories use. Our materials boast of very low voc's so the air scrubber doesn't have to do much work.
• After work is completed we start to tear down all masking and clean up. Once everything has been removed we do a complete cleaning of your kitchen.
• End result, you have a beautiful kitchen with a new factory finish look and you cannot tell anyone was in your home.
•  During this process you have access to your kitchen and sink for the entire time except when we spray the primer and top coat which is only couple hours over 2 days.